Bush Hog 865H Manual del operador Pagina 11

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 36
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 10
SECTION II
PREPARATION FOR USE
Figure 2-1
Tractor Drawbar Adjustment
WARNING
9
G. Unpin wing lift cylinders at rod end. Fully ex-
tend cylinders by pulling on clevis. Retract cylin-
ders using hydraulic valve. This removes most of
the air from cylinder. Repin cylinders.
H. Attach driveline on tractor and cutter with con-
stant velocity joint at tractor. Pull on each driveline
section to be sure yokes lock into place. Make certain
driveline shielding is in place and in good condition.
I. Attach driveline shield chains from both ends
of driveline shielding to stationary location.
NOTE: The shield around the constant velocity
joint should not be chained in place.
J. Remove jackstand and pin in storage position
USE A PIECE OF CARDBOARD OR WOOD
RATHER THAN HANDS AND WEAR EYE
PROTECTION WHEN SEARCHING FOR
HYDRAULIC LEAKS. ESCAPING HYDRAULIC
OIL UNDER PRESSURE CAN PENETRATE
SKIN. IF OIL IS INJECTED INTO SKIN, IT
MUST BE SURGICALLY REMOVED WITHIN A
FEW HOURS BY A DOCTOR OR GANGRENE
MAY RESULT.
2-1 ATTACHING TO TRACTOR
A. IMPORTANT - Adjust tractor drawbar length
to dimension shown in Figure 2-1. Incorrect draw-
bar length will change angle of driveline causing
possible damage to constant velocity joint. Do
not use PTO adapters. Use of PTO adapters will
invalidate your warranty. See operator’s manual for
drawbar adjustment procedures.
Bush Hog offers a driveline to match your tractor
PTO shaft. The proper driveshaft should always be
used instead of a PTO adapters.
B. Raise cutter using jackstand until tongue is at
drawbar height.
C. Connect cutter to tractor using 1-inch (25.4mm)
diameter approved pin with lynch pin retainer or equiv-
alent.
D. If connecting cutter hydraulic lines directlyto trac-
tor, wing hydraulic lines must be connected to tractor
outlets that permit flotation ofwings.
E. If optional valve is used, mount as desired. If op-
tional valve mounting bracket is used with valve, at-
tach to tractor as described in paragraph 2-2.
F. Connect hydraulic lines to tractor auxiliary out-
let(s)
Vista de pagina 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comentarios a estos manuales

Sin comentarios