Bush Hog 865H Manual del operador descargar pdf (Pagina 10)

KEY OPERATION POINTS

• Cutting performance and distribution are best when cutter is level from side to

side and front to rear.

• In extra heavy material, rear chains will allow better discharge and better distribu-

tion than solid rear bands.

• Never operate the Flexwing below full PTO speed of 540 or 1000 rpm.

• For good distribution, the distribution baffles must be used.

• Deck rings may influence the quality of distribution.

• Deck rings will cause additional mulching in heavy grass and corn stalks.

• Corn should be cut at 5 to 6 mph. If full PTO rpm cannot be maintained, use one

lower gear.

• Corn yield of 180 bu. per acre will require a minimum of 105 pto horsepower to

shred at 5 to 6 mph. To maintain the suggested 5 to 6 mph ground speed when

cutter is equipped with deck rings, a minimum pto horsepower of 115 is

recommended.

• ALWAYS OPERATE WITH THE WING HYDRAULIC CYLINDER CONTROL VALVES

IN A FLOAT POSITION.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Sin comentarios

Bush Hog 865H Manual del operador Pagina 10